jobrated_man
www.39-47dodgetrucks.com
Replacing the wheel bearing on my 1959 D100 and find that I need more shims to set proper end play on the axles. With bearing race or shell tapped in to flush with the housing, it is too tight, and axles wont turn. I need those shims to get some spacing behind the support housing and backing plate. I know the factory made them in .005, .0125, and .030 thickness. They are abouto 4.5 inches in diameter, and 5 holes. Can't find anywhere, - would rather find stock instead of cutting my own out of steel. ideas?