Recent content by tfinley

Yea it has the bigger yoke. I don't know if I can have the drive shaft change to fit?

I have a dana 70 out of a 1991 dodge dually. The rear end has 307 gears. Does anyone know if it will work ok with a granny low transmission. I am trying t get less rpms on the highway, thanks for any help.

Your truck is coming along great!

I still have the granny low 4spd. I will do the nv4500 swap this winter. I am ready to drive it! Its time to haul firewood.

I guess not much interest in the old truck? Its just about complete. I did all of tne paint work in the garage. Redid the flat bed, along with new oak running board and hand painted old school signs. I am putting a new wire harness in it right now, from Rons wiring. Here is a couple pics.

Any grilles left

Looking for a 1979 dodgectruck grille if anyone has anything thanks

Do you still have the grille thanks

The truck is a flat bed truck. The plan was to install new 1/4 inch steel tread plate. Make new running boards out of oak with old school shop signs. Then new stacks, like the lil red express. The truck is going to be painted two tone black and maroon. I painted a fire tuck last year at...

The motor was leaking and had water in the oil. I looked on craigslist and found a 360 in a RV. The owner said they could not find the keys and they have not drove it for twenty years. They stopped driving it after they broke several lugs off trying to fix a flat tire!!! When i arrived at...

I have the doors and fenders in primer and the pics that i can find of the cab are also in primer more pics