victa15
Active Member
So I picked up this dodge truck for a few hundred bucks. I'm going to use it as a parts truck for my powerwagon. The guy I got it from was sad when I told him but it's because he cut the roof off and the doors. There is no structure anymore lol. But it has a mild built 400 with headers, Eddie intake and a brand new Eddie carb. Not including new starter and new fuel pump. I want to swap the engine and tranny into my truck which has a 318 in it right now. Would I have to do anything on my truck to make it fit? I want to swap axels cause they are 3/4 ton and mine are 1/2. Plus it has a 6 in lift with 38.5 inch tires on it. But I can't figure out the rear end. I think my front is a Dana 60 but the back one is a 14 bolt rear with n6969 stamped on it. I need to clean it off more to see more numbers. I included pictures of the rear and front diff