Recent content by TopHat

caster +1/2 degree camber + 1/2 degree toe-in 1/8 inch

I looked at the matco tool, almost pulled the trigger on it, but didn't. I might slide a piece of exhaust pipe over a wrench a dozen times a week as a cheater, but I still have not seen where this would make my life easier.

All depends on what you want. A 3 chamber flowmaster style should sound good, without being overbearing. If you can mig weld you could do that yourself, dumping in front of the rear tire. A single in dual out flowmaster style muffler, dual tailpipes custom bent and routed around your spare tire...

I have a gull wing box in my truck, that works rather well for me. The style of box you are showing, I would need to climb in the bed of my D250 to get to most things in it.

Your sensor should be held to your valve stem by a tiny torx screw, on the inside of the wheel. Replacing the valve stem is not mandatory, though a good idea. The sensor has to be programed to the vehicle, and the wheel position. There are ways to put the vehicle in "learn" mode and then going...

I ordered the rislone today, should have it before I change the oil. I do use the Valvoline VR1 in my gas flat tappet engines, including my dry clutch motorcycle. For a diesel engine I would rather add zinc to a diesel rated oil.

https://rislone.com/wp-content/uploads/2014/11/4405-Tech-Sheet-1.pdf I'm thinking of this with cj rotella. Opinions?

So what addative has the zddp we need now that cj rotella is all that is aviable?

Might try here Product Categories

I have not tried that one. The slant distributor has the gear attached to the shaft and the V8 (assuming the same as the 3.9) has the gear built on to the oil pump drive. You might be able to build something yourself using a V8 either points or electronic body and a slant points cam or reluctor...

The latest addition to my fleet is a 93 D350 club cab. The passengers seat was unbolted when I bought it. I saw the seat "pedestal?" and didn't think anything about it. Now after looking, it seems the seat hinges forward like a Ramcharger for rear access. I am missing the hinge and latch. Are...

Seriously love that blue and white rollback

Just struck a deal and bought #11 yesterday, and will be bringing it home tomorrow. The fleet is strung out between 2 houses, I'll have to get some pics up soon.

30+ year pro wrench with 10 Dodge trucks, looking for #11. lol All slants and small blocks.