Blower Motor Resistor PN 3556609

[MikeG]

I have a 1979 Dodge D100. Looking for either a solution for wiring up the blower motor resistor or buying a 3 pin resistor.
I'm not sure what everyone is doing once these older resistors go out, I can't find a replacement part anywhere. There's one listed I found however, it's untested and looks a little on the rough side.
Any Help is greatly appreciated.
Thanks
Mike

 

[MILO]

Is this the one you want

Mopar NOS 1979-81 Ply, Dodge, Chry, RWD Heater Blower Motor Resistor 3847094 | eBay

1979-81 RWD Heater Blower Motor Resistor-NOS 3847094. OEM Part # 3847094. May do other later Year Vehicles, but do not have the Parts Books to Confirm. 79-80 Volare & Aspen with Heater only. 79-81 Lebaron & Diplomat with Heater only.

www.ebay.com

 

[MikeG]

Hi Milo,
That's a close match. My blade configuration is different though.
I haven't dug into checking the resistance of different ones; if the resistance is the same I could always jumper the plug configuration to the pins on the resistor.
Thank you, I may have to get that one and test.

 

[MILO]

Here is one cheaper with free shipping in the states. The other one may have a terrif

Heater Blower Motor Resistor# 3847094 - F - M - Body - 1979-80 - NOS - SHIPS FREE TO LOWER 48 - Blue Star Performance

Heater Blower Motor Resistor# 3847094 - F - M - Body - 1979-80 - NOS

bluestarperformance.com

 

[7mopar]

Try finding one for an 82 a/c truck. My only choice will be to change some wire end locations and hope for the best.

 

[7mopar]

Haven't been here for a few weeks. Been busy, plus the internet has been friendly about getting here. Going to get slapped with more winter later this week. Still got some prepairing to do but have a good start on laying out TT skirting.
Been working on a Dodge Caravan to drive and finally have it plated. Not done by any means but road worthy.
Need to get started on the D350 as it has an appointment at the inspection station on 12/2. Only thing holding it back is the horn not working. But the heater fan dosn't either. Get the fan to work likely the horn will work also. Both on the same fuse that keeps blowing.