Recent content by Terryp

i have an extra wood grain insert, a 4wd light , warning center for a ram charger i have a complete a/c control with vacuum controls, i have a complete owners Manuel for a 1990 dodge ram with radio Manuel owners manual the sleeve the tire pamphlet the camper pamphlet, i also have 1 extra fuel...

can some one plz tell me where i can get a power steering pulley for my 89 d150 with a 5.2 tbi i cannot get old one off pump and wile trying destroyed it and cannot seem to find a replacement one tia

hi guys im looking to buy a mopar 9.25 rear end that will bolt right up to my 89dodge ram d150 needs to be in Gatlinburg tn area thx in advance

Thx im looking 4 one that i can put 3 90s and a sure grip in i already plan on all new barings and seals

Hi im looking 4 a mopar 9.25 rear end w 5on 5.5 spacing that will fit my 89 dodge d150 need to be near Gatlinburg tn area

thx for the help but i patched it together for now with allimminum bailing wire hope it last a while

So I have a 1989 dodge d150le 318 tbi truck the factory temp sensor has to be plugged in when cold or truck won't idle but when it gets to temp truck surges In power if i unplug it when hot truck runs fine any one had this problem or have any insight is appreciated.

Anyone in the Gatlinburg tn area and has a 30 gal fuel tank and pump housing for an 1989 dodge ram d150 318 tbi if u dont have a tank I can make a fuel pump housing work mine fell apart and i need one asap

Anyone in the Gatlinburg tn area and has a 30 gal fuel tank and pump housing for an 1989 dodge ram d150 318 tbi if u dont have a tank I can make a fuel pump housing work mine fell apart and i need one asap

Has any one changed the factory computer in a 89 dodge d150 with a 5.2 tbi going to replace mine any tips or tricks on getting old one out and new one in

Is there any way to make it down shft sooner

Thx for all the help loving the adjustments I did struggled with them at first then figured out I was missing the spring that hold the kick down rod forward now adjusting it is working got the 1 /2 shift perfect but the 2/3 3/4 shift has a dead zone and takes a few seconds to down shift

It is controlled by cable not computer

So what here do I ajust

Hey I need some help I have an 1989 dodge 318 tbi with the 904 with over drive when I put it in deive and floor it it shifts at about 3500rpm I won't it to shift about 5000rpm what do I need to ajust or get to do this any help is appreciated thx