I have a rf & lf D100-150-250 fenders and some running boards for sale. Fenders are $75 each or both for $100.00. Yes there is rust holes at the very bottom.
Running boards for all $100.00 obo. location union sc 29379. no i will not be able to ship pick up only.
unwrap
you may find that fire wall block will not have the same pins as yours and lots of bad insulation on the older wiring. unwrap yours strip out the bs. leave at least 6" of wire out of the fire wall block (just in case). it will be a lot less frustrating and you will know that you have.
trying to find headers myself
I have spent the past 2 days looking for headers I checked bpe http://www.bpeusa.com/BPEheaderManifolds.asp
as you can see the #is bpe5905 so i dropped the bpe and did a search of 5905 and got got hooker headers...
1967 383 out of a Newport with a 1970 roadrunner cam and 383 magnum intake other wise just freshened 727 was out of a 1978 dodge ambulance only 51,000 miles on it.
I really enjoy all the trucks on here the 79 power wagon brought back some memories. my dad had one when i was in high school.
found out it has 2.91 gears and decided to leave the stock d150 axles was getting 12mpg with 4.10 gears so hope to get a few more miles per gallon. should have a nice top end speed:bounce:.
memorial weekend
got some more done memorial day weekend front fenders, hood, wiper trans with new bushings, put some screen on the back side of wiper valance almost filled a 5 gallon bucket with leaves and pine needles had to fix that. taped up wiring harness, front sway bar, removed rest of...
about that much room
ok 1984 d150 2 wheel drive 383 b block i got 6 1/2" top of carb to hood insulation there maybe a extra 1/4" hood was setting flat on cowl no front fenders on. 10 1/2" from intake carb mounting to hood. i have a 1" spacer block under carb so you could say 7 1/2" with out...
Running again
Got her fired up today. forgot to plug the vacuum boost line so she wasn't idling all that well. but felt good hear.
http://www.youtube.com/watch?v=t592eUoqEM8&feature=youtu.be
finally stopped raining
Have had much time to work on her I did get the headers on spent 2 days getting the matting surface on the headers flat so they would seal right. Note to self never buy cheap headers. also got the inner fenders painted and on that was before what seamed like the never...
fuel pump relay
find the fuel pump relay use a jumper wire to the #86 terminal to the battery you should hear the fuel pump run. next remove jumper wire and only hook up wires from the unilite red to positive side of coil green to neg side and brown to ground. also get a coil from a 81 or 82...
the tbi was computer controlled the fuel pump may not work if it had a sensor that let the computer know the engine is turning over. i am not sure about this just a thought. also my dad put a 340 in a 89 short box that had a tbi and was not getting 12 volts to the coil so check that voltage.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.