Recent content by Dan Mckillip

Thanks. X-fer case is separate from trans, so no problem there. (Pic,three drive shafts) I think I'll need to scrap intention of pulling both eng & trans as one. it seems Id need to drop the trans down 3" to clear firewall sheet metal (see pic). I'll try separating bell housing from trans...

Picture of cross member under trans. Not sure if i need to pull this X- member or not.

Preparing to pull engine/trans as one. Already pulled rad, all engine accessories, shift levers, access plate above trans, exh manifolds, dist, carb, water pump, Unbolted trans mnt & trans mnt x-member. Question: do I need to pull the x-member under the trans(4 bolts per side) I hope not, but...