Recent content by Clint Bazemore

Looking for a good home for a set of wheels. In search for someone who will put these wheels on their truck and enjoy them not sell them. Free to a good home. Cleaning out my storage unit. Must be able to pick up in Mebane NC.

I have an 86 and 91 LA 360. Both apart. Also have a 727 4x4 transmission with a 208 transfer case. Also have a lot of other engine parts including intakes, carbs brackets. I collected these parts with plans to build a stroker motor for my truck. Ended up finding a truck that already built and...

Just picked up a1987 D150. What is everyone using for driving lights? Need a little more light while driving at night but don't want to cover up the front of the truck. I really like the look of the first generation dodge trucks. Thanks for any ideas.

Pulling from a 1986 d150. Almost got it started but seems something is holding it back. Asking $1.00 for it. Free if you pull it. Condition of drivetrain unknown. Does have a new starter and alt. Truck is located in Gibsonville, NC. No shipping. Thanks, Clint.

I pulled this from a wrecked bus. Think it should work

I think that will be the path I take. Hoping for enough slack under the dash that I can do this all in the engine compartment. Too old to lay in the floorboard more than 10 to 15 min. I will pull out the connector and cut all the wires so I can take it to the garage at home. It has AC. I'm...

Me again. Went to work on the truck this morning. Same issue with the wiring. I have done more research and think my issue is the bulkhead connector itself loosing contact. Unplugged it and ran a jumper wire to the inside plug and power stayed the same after turning the key on. Before the...

Thanks for the input. My gauge is part of the cluster and a plug. I got a chance to go tinker with the truck this weekend. Found a fuesible link that was not playing right. Cut it out and ran a jumper wire to the wire. Full power at the fuse box. But I think I am missing a few relays beside the...

It will be Friday before I can get back to the truck. I will take more test equipment and check everything that has been brought up. Thank you all.

Yes. Everything connected and under the hood I am getting battery voltage before and after the fuesable link key on or off. Under the dash I get battery voltage until I turn the key on not started. Voltage drops to 4 volts and less.

Other than turning the ignition switch on and off I have not. Watched a few videos on YouTube about replacing all the power circuits to get rid of the fuesable links. I think that might be a quick repair versus driving myself crazy just looking for the issue.

I have not checked that area yet. Just can't understand how power can change from one side of the bulkhead to the other on at least three different wires.

Me again. Just picked up a 1986 D150 short bed. Thinking about selling my 4X4. Getting older and the Two wheel drive is closer to the ground. Having a voltage problem from under the hood to under the dash. Truck has starting issues. I have checked the wiring from the battery to the bulkhead...

Looking for a factory service manual for my 1986 d 150