Looking for a clean upper/front roof section for a 1972 Dodge w200 (or a year that will fit). Need from 6 inches down the front window posts/channel up to about 6 inches into the roof (trying to fix the typical front roof rot). Need something rust free. Also, need a door panel for the driver's...
How has this not sold yet???? This has all the right stuff and would be perfect for a youngster transitioning out of jr dragster. If you haven't already you should put it on Racing Junk and Yellow Bullitt. Good luck with the sale.
Finally got some decent pictures of my 72 4x4 W200. She has factory a/c, p/s, p/brakes and a 727. Shes got some rust but mechanically shes all rebuilt and reliable. I'm the second owner. Unusual color combination but I have the factory invoice and that's how it was ordered.
Nice combo. Just my opinion, if your going to stick with the 290 gears I would go with the 710 voodoo. With the larger cubic inch I would also use the performer rpm intake. It's rated for a little higher rpm than you need but will come in a little sooner with the bigger engine. Also take a look...
Seven is right, motor plates and a mid plate would be the way to go. I would still use a insulated rear trans mount. You'll going to end up fabricating a trans crossmeber which you could incorporate your driveshaft loop into. The plates will allow you to set up your angles and will make your...
65 that's the fuel pump/filter setup. The tank is no longer in the cab. There's a fuel cell under the bed just behind the rear axle. It was my daily driver in high school and it did a lot of jon boat towing back then. Thanks all for the compliments. Have to get some pics of my dodge up.
Here are some pics of my 55. I have to take a few of the Dodge and I'll get them up as soon as I do. That is awesome Scott. Mine is a fleetside. I'll get some pics up tomorrow
Hello to all from South Florida. Have a 72 D200 crew cab 4x4 (stock) and a second series 55 Chevrolet drag/street (had it since I was 14-now 53). Looking forward to the knowledge shared on this site. Hopefully, have some to share with you all.
Rick if the top of the windshield area/windshield channel is rust free i would be interested in that area of sheetmetal. Let me know. Thanks in advance
Looking for a clean upper windshield frame for a 72 w200. need from the upper window channel up to about 6 inches into the roof (trying to fix the typical front roof rot). Need something rust free. Also need a door panel for the drivers side front door. Its a crew cab but i dont think it...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.