Search results for query: *

Looking for a fixer upper 30s 40s 50s or 60s, prefere a full cab

Nope, winter came and it sits lol, what you need and I’ll look to see.

I’m parting out a 79 Ram Charger body, keeping the drive train. It’s rough other than the hatch back top piece. Ok doors, fenders and hood. No grill. If no interest it’s all going to scrap yard in 2 weeks. In eastern Va. no shipping, cheap

A closeup pic of the two cowls would really help to see difference. Is that too hard?

hope this is the right spot to ask question, looking for a shortbed frame or rear frame section around spring perch for a 79 Lil red Dodge. Thanks

What I’m looking for is the tilt steering exploded view of the low-high beam rod next to ts lever. I took mine apart but can’t get it back. My 88 SM (early) book still shows the switch in floor. Thanks

I need the turn signal-wiper arm for a 1988 dodge pickup with cruise, I picked up the other pieces but the doner truck was missing the steering column. Message me here.

Walmart brand two stroke oil, what they mix with the gas. I buy by it the gallon, a quart every fillup. It’s DESIGNED to keep the carb-reeds-combustion chamber clean on chainsaws. Works great on common rail diesel injectors

Yes I’ve seen the kit for OD but I’m also wanting to do the cruise control also from the 92 Van. Looked again at the Van harness and it looks doable using everything (long enough) tilt steering column too with some fabing. All I’ll need then is the cluster from the later model truck.

Yes thinking the wrong thing meant the42RH. And I’ll be looking for the 8-1/4 3.55 gear (I have 5 cars with that rear) probably all low numbers though. TQ and the S2P2 intake is on the plate too.

I want to use the 42RE in my 87 and I’m looking for the wire harness from the newer pickups to do this changeover. An electric speedo is needed to, maybe the whole dash too, pm me here please

There’s no difference in the bottom end between LA and Magnum

What part don’t make sense

Lil red, and I’ll try to get a picture of that area. I was thinking the same about welding on inside only with plug welds. Many years ago an old welder said not to weld vertical on a frame just horizontal. Trying to reaffirm that

I have a 79 Dodge and it has some rust at the front hanger on rear axel. Should I get a section of frame or can I use strips of 1/4” plate. I’ve heard how not to weld but willing to hear advice. Not an everyday vehicle but I don’t want it cracking going down the road either. Thanks in advance...

I can get my hands on a 4x4 1987 complete frame-axles and was thinking of using the cab and bed off my 88 2x4 truck, just switching over the parts. What auto trans and transfer case would I look for (I want the manual selector on transfers case for the 4x4). Do I need Anything else?

I think you just turned on a light. I read awhile back from a guy who worked in the service dept. at Dodge. He said all Chrysler’s cars-trucks have a clock in the PCM that they only can turn off and reset it. If done with the handheld chip readers the clock is never changed, then periodically it...

Got trans back in my 01 Ram Van, works fine but gas millage dropped from 15 down to 11 mpg (checked over 3 tank fulls). Seems to run ok but maybe a little down on power, any thoughts? My dash keeps saying no bus, could the PCM be going bad?

10% alcohol has ruined the carbs, the new one will do the same like filling it with water and letting it sei for a few months. If you can find just straight gas, use it or add Sta-bil, Marvel mystery oil or even better the 2 stroke oil from Walmart brand. One quart every fillup.

Neat car