Search results for query: *

Maybe so but it doesn't look nice under the hood. End game is I have a 318 to put in it and then I can get rid of almost all of the vaccume lines. That's a project for another day though so I can build it the way I want it and be done.

Hey all been a while since I posted on here. I've been working on my 89 d100 and now I have a question for anyone that may have done something like this. The truck has a 3.9 fuel injected engine, I'm pulling the motor and trans to regasket everything and clean it up. I would like to clean up the...

Well thanks anyway guys but I put it down in the ground last night and it sits way to low for my taste. I'm going for a nice stances truck not a snow plow. I now have to modify the stock arms to take a 3/4 bolt. Oh well. Thanks again.

Ok everyone. I know there is a million posts about this but I have a specific question about this. Hopefully I'm not the only one this has happened to. I completely rebuilt the steering and suspension in my 89 d100. I bought 2" drop shackles for the rear just to reduce some if the rake from...

Old gear has 350/917-3.90 stamped on the side and nothing that makes sense to me on the top. New has I'm guessing manufacture numbers and that's it.

I am a manual machinist. Can you post a picture of the depth tool you have when you have time please? I might be able to make or just buy one. I'll check the new and old pinion gear when I get home from work to see if there is a depth stamped on one of them.

Even if I'm not doing it all the time I'd still like to know how so if I ever have to do it again I'll know. I'll look for that tool. Are they make specific or universal for all makes and models with a diff?

Oh. Ok. Well as much as I hate to say it I guess I should take it in. I hate paying for something I can learn to do but everyone I know says pound it on with an impact and I know that's not the right way.

How do I know if the pinion depth is right?

Ok so set the rolling torque, mark it, disassemble and reassemble with new seal and lock-tite on the pinion nut threads? I just checked and I do not have extra bearings. I do have 2 seals and 2 crush sleeves. I just really want to do this right so it can be my daily driver again.

Yeah that is weird. I'm mainly confused by the rolling torque and then crank it down to 210 ft/lbs. I assumed the rolling torque was the preload and wouldn't the 210 mess that up?

I just mean if the carrier is correct side to side so the mesh is right and the bearings should be torqued to 70. I don't know. I do have a Chilton manual on the way I hope that will help. Not sure if I have a trial bearing but I do have 2 crush sleeves.

Hey everyone, I got another question. This is my first time rebuilding a diff. 1989 d100 8.25 I am replacing everything (gears, crush sleeves, bearings, and seals) I looked in the Haynes manual but its not very clear and I have looked online and none of it makes a lot of sense to me. I am...

Can do the rest

Ok. Thank you. The shop

Yes I replaced everything. Upper and lower arms, bushings and hardware. I just need to get it good enough to drive to the alignment shop.

I may have this post in the wrong place and there may already be an answer out there somewhere. I have an 89 d100 and I replaced everything underneath. Now I need to do an alignment. I looked online but I don't have good luck with that. Anyone here know the process and what bolt does what to...

Alright. Thanks

I just noticed those parts say 1 inch level spacers. Did they lift the front end up?

Ok cool. Thank you.