Search results for query: *

i,d put twin hairdryers on it with a blower on top with a digital fuel injection unit. Should be good for 2000+ horse. And run on pump gas in 100 degree heat at 180* in traffic. I miss the join date in the avatar.

hey yall,been a while since i was here.

Howdy

two years and i aint done a thing.

hope you find some goodies

Seems a short spring would work if it had a stiffer spring rate. Id pull them and lower the body with a floor jack where i wanted it and see if i could adjust yhe camber? till i had a decent alignment. You might could get a few inches. Then you could see how tall you need the spring compressed.

Is it coil spring in front. If so maybe find shorter springs in the junkyard

79 ramcharger is stacked

thank yall,

another pic. Kinda looks like tow mater.

Found another front clip thats not quite so raggedy and started fitting it to the frame.

Where they are?

Looking at mine I would pull the front clip to do it.

Welcome.Daredevil here from fabo and fbbo

Springs here. How about an update?

Nothing new to post. Working on wife's barracuda

I have the full set and they will be on it. An added plus is the front hubs fit thru them when i take out the center caps

Got a few small showers this week but still dry as hell. When I walk in my yard the grass crunches. May roll the wifes 69 Cuda in the garage turn on all the fans and start her motor swap.

Getting too hot to do anything outside right now. May have to wait till end of summer.

53 must be wider because it looks right. Biggest obstacle so far is motor sits back in cab a couple inches and to center steering collumn to one side of truck I will need two steering joints to connect collum to box. Its about a 3 inch offset.