Recent content by MBF49er

The end of that wire like spring goes through a hold in the Z-bar that hold the inner nylon bushing in place. As long as the clutch arms are properly oriented you may be able to shorten the tube, but measure the distance from the end of the tube to where the holes for those springs are so that...

Did you bench bleed the master cyl before installing it?

Thank you PH27L7!

Thank you for the leads-I'll check them out!

Is there a replaceable bushing that goes into the ball (bell housing) end of the z-bar? If so-anyone have a source or part number? Thanks in advance. MBF

Is there a replaceable bushing that goes into the ball (bell housing) end of the z-bar? If so-anyone have a source or part number? Thanks in advance. MBF