Recent content by Kenneth

That’s good. I thought I had read 6 some where but ? Any good literature on 2 barrel Carter carb rebuild ? The carb Kit comes with a diagram but the parts are tiny and it doesn’t show how some fit. I put in a new accelerator pump piece yesterday and couldn’t figure out shaft retainer pieces So I...

I just changed the oil. I put six qts in but now I’m thinking now I should have put 5. Oops

Along the same lines. My wiper isn’t working either 72 d200 and the fuses are not labeled for wipers and the manual doesn’t tell you either. Anyone know which fuse by any chance ?

I put three gallons of fuel in the tank today and I’m not getting any fuel coming out of the tank. The truck is sitting at a slight angle with the low side being the driver side. I guess I need to put more in just to reach the sending unit tube.

Here is a pic after beating the dents out a bit 😬 I’ll have to try and hammer it with a dolly to clean it up a bit more before filler or like is mentioned find another fender. PO already put a thick blob or two on lower area in front of door which is coming loose

I beat the driver side fender out from behind. Looks much better. Eventually I’ll go at it with the bondo. Fuel tank is installed. The next thing I want to do is get window rubber as all the water has rotted out the bottoms of the doors. I see a number of generic kits online. I suppose one is...

painted

Cleaned Lined and painted gas tank ! installed new fuel sending unit and rubber grommet for filler pipe. The new grommet isn’t like the old one . One side has a round part to it. I’m not sure which way goes up. I’m not sure it matters so I put the round side up ? 🤪

It’s out. Now I have to decide whether I just clean it the best I can or clean with acid and put a Por 15 kit in it. I’ve done a lot of motorcycle tanks but nothing this large. I think it’s 30 gallon ?

Thank you for the information. Today I may try and pull the old tank out if I can figure out how to remove the seat :)

Just bought a 72 D200 ? Badges say custom 200 . Original papers mention Utiline. From the vin it looks to be a 318. Anyone had any luck finding a fuel tank for one of these? I suppose I’ll put a liner in the one I have. What about chrome fenders. ? Would D100 body parts be the same ? So many...