I would ask the same question, yes I have a complete shop and have been building Streetrods and musle cars most my life. I am currently finishing a 57 Chevy cameo ls3 full vette suspension very nice truck also just started a Airstream trailer and I know nothing about but it is something...
I have not brought it in the shop yet but am trying to obtain all the information before I start that and I am trying to finish a airstream trailer and a 57 cameo then it is the 87 I do know of someone putting the 5.7 in a dodge adventure and I think it all bolted up but the top center bolt on...
This is a 4x4 truck cab, I was hoping to swap the body but if axles are two wide I would like to swap the engine and transfer case over and automatics to the old body and use the old front and rearend on the 87. I am trying to figure out if motor mounts and such would work. It would be great if...
I would like to do a complete transfer including all dash components steering colum. I know I might have to shorten the frame and drive shaft. I have the cab and all components to do it infact the cab I have is very nice so everything is there. Thanks again any help is appreciated. Don
Has any one put a 5.7 or 6.1 in an older dodge pickup I have thought about putting my older body on this 2013 Ram frame which already has complete motor transfer case tranny everything to complete or would it be easier to transfer everything from the 2013 into the frame rails of the 87 dodge...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.