well I don't know for sure on the trans code is I haven't been under the truck in a few minutes. But the research I have done is the 12 inch and the 11 inch clutch do not match with the number of splines and the size of the shaft, I have not been able to find a 12 inch clutch that matches the...
yes I am , leaving the magnum stock. I did find out it was a crank sensor, which is what I thought. I really want to keep the trans, so I can use the grannie gear when I need it. and living here in Alaska I use it all the time.
so plan A is to purchase a 2001 flywheel which takes a 12 inch...
I am working on a 5.9 magnum engine swap into my 77 dually with a 4 speed. And I have a few questions for the guys who have done the swap before. first question is I am guessing I need to use the original clutch flywheel. 2) pilot bearing, which one should I use, I am guessing again I need to...
So, I have done a few things to help with my testing process. long story short the sending unit in the tank has issues but I have not gotten to it and replaced it.
I measured the ohms, before I filled it and it had about 40 ohms. I started to fill it and noticed that the ohms nor the gauge was...
At this point I need to run this truck down to the gas station and fill it up and watch what happens, so until then I will let you all know as soon as I get the answer.
and as far as cutting the wire, dude if you saw the rats nest under the hood and this truck you won't be too concerned about...
I installed the aftermarket gauge with a different 12 volt ignition source and the gauge is also grounded
I cut the wire (blue )going to the cluster and ran it directly to the aftermarket gauge
I have to check my fuel and see where the level is right now
I believe it’s 3/4 tank but maybe it...
Sorry guys had other issues come up,
So the link below is the aftermarket gauge I installed. it is suppose to read 73 ohms when empty and 10 ohms when full. which I believe is backwards from what I learned here on this forum. I could not find a gauge that read the other way and a few of the...
I see a bunch of people have swapped in a magnum motor in to the older dodges, But has anyone done the complete swap with the trans and transfer case.
I can't seem to find anyone who has. I would like to make this a daily driver, with the smoother shifts and overdrive feature.
I have a...
So I have a 23 ram rebel with the large display screen. the truck came with software package that allows you to chose what trailer you are towing and make changes to that trailer software to configure the trailer. it also has a light feature that when you select check lights, it will flash all...
Okay gentlemen, The next/current new gauge came in and I installed it and it's better BUT, it reads back words from what I need. At empty it wants to see 70 ohms and full it wants 10ohms. This is back words from what I need.
So the truck has 70 ohms full and 10 ohms empty, which I have measured...
So I have ordered the correct aftermarket gauge with the correct OHMs, I never knew that about fuel gauges, I ASSUMED a fuel gauge was gauge like a volt meter, it didn't matter. So i have to thank you guys for the help, when the new gauge comes in i will install it and let you guys know.
I have a fuel gauge problem that seems simple but still isn't working for me.
I have a 78 snow commander, (I love this Machine)The dash has melted from the amp meter, and can't find another
The sending unit in fuel tank sends a restricted ground to the gauge depending on the amount of fuel in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.