Like title says W200, DANA 60's front & rear, 360., factory A/C but it does not work. Cab, floors and mounts have no rust. Located outside of Denver, Colorado.
$11,500 or offer. Add is here with pictures and I can furnish any pictures you might want: 1980 W200 Crew Cab 4X4 - Dodge...
My new to me 1996 5.9 when first started idles about 1050 RPM then drops down to about 850 RPM after say 20 seconds, it does this hot or cold, it sure would be nice to have it idle around 650 or 700 RPM, any suggestions would be appreciated, Thanks!
I had the gas tank out of this truck about 4 years ago, cleaned the crud/water out of it and now it seems to have water in it again. It is a behind the seat tank, a locking gas cap that seems to fit pretty tight to the filler neck. It is only used as a plow truck in the winter & sits 99% of the...
Just a curious question, late 70's DANA 60 front axle with the big locking hubs and discs. What is one in good working order worth these days?
4:10 or 4:11, not sure which ratio it is.
Thank You!
I have a 1980 Crew Cab, the tag on the door says the front axle GAWR is 3,880 #,
call the parts store looking for calipers and they have options for:
3,500 # or 4,500 # front axle. I guess I would use the calipers for a 3,500 # axle?
Thanks!!!
I have a 81 D200 with a DANA 60, the wheel bearing nut is a nylock single nut versus the old two nuts and a lock ring, could someone give me a wheel bearing nut torque spec? I would guess you tighten it to like 150' lb, spin the hub assy., back the nut off then retorque to a very low spec. but...
I was hoping if someone might be able to tell where I could find the wiper motor breaker? The FSM says there is one in the circuit, but, fails to tell you where it is. I can't seem to find it in the fuse panel.
My wipers run for a while then quit then they will come back on.
Thank You in...
I think I have a 79 1 ton Dodge Crew Cab, 2 wheel drive, have calipers, rotors, spindles and anything else on the front suspension if you need anything. Have hood & fenders as well. It has Quad headlights.
$150.00 or best offer plus shipping from 80421 (Bailey, Colorado)
Does onyone here have one of these factory diesel's? I didn't realize they were made till I saw a thread in FABO that showed this one. Would love to be in contact with someone that own's one.
http://www.curbsideclassic.com/wp-content/uploads/2012/11/Dodge-D200_diesel_01b.jpg...
I just bought an 1984 W150 with a 318. It had electrical issues and the previous owner has done a hack job on the wiring. I just got it running but the ignition syst. is laying all over the place. I found where the ignition box bolts to the firewall under the master cylinder, but can't find...
My 1977 Plow Truck, rusted floor boards but in OK shape other than that. It comes in handy once in a while here at 8,700' in the foothills outside of Denver.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.