Recent content by Reed

I am looking for an engine wiring harness for a 1992-1993 318, or a 1993 360 from a Dodge Ramcharger or D series full size truck. I am also looking for a 1993 360 ECU. I can trade a rust free good condition 1976 d series short fleetside bed or pay cash, if the price isn't too much. If you...

Looking for a 2 wheel drive A500 transmission near Tacoma, WA for as cheap as possible. I would like it to come with a torque converter, wiring for the overdrive switch, and cross member for a D series pickup, but really all I need is a torque converter and the trans. Any leads appreciated.

www.vanning.com Showvans.com ~ showcasing the top custom vans and van events across North America Home | '71-'77 Mopar B-Van Forum www.slantsix.org To name a few other websites that have discussions about Dodge vans.

These adapters were installed on 64-67 Dodge A100 and A108 trucks and vans, as well as in taxis, cop cars, and other fleet vehicles that used a slant six. I need the adapter as well as the crank spacer. I need it to be fairly close to the Puget Sound area since shipping will be expensive. The...

Properly functioning EGR potentially allows one to run more timing advance without pinging. I still need to verify the system works properly but for now I want to keep it. If I run into problems with it, disabling it is no big deal. Perhaps I had my slang terms confused. I always understood...

Sorry, my post should read part time 4wd was introduced in 1980, not 1989. By an "RV" cam I meant a cam designed for low RPM torque.

Positive about part-time four wheel drive. The transfer case goes 2wd-4wd-n-4 lo. Still has the factory automatic locking hubs in the front. Part time 4wd was introduced in 1989 on the Ramcharger. Prior to that Dodge used full-time 4wd. If I could find an Edelbrock SP2P four barrel intake...

I recently got what think is a true 44,000 original mile 1982 Ramcharger powered by a 318. The truck is totally stock and was maintained at a local dealership. The truck has part-time four wheel drive and is a big heavy un-aerodynamic box. I would like to maximize fuel efficiency on the...

OK. After studying the profiles of the replacement supports closely on www.dodgeconnection.com I believe this is the third brace back form the cab, or the middle-most brace for the bed floor. I will have to measure to be sure once I get the bed on.

I found a mostly good condition stepside bed for my 76 D100 shortbed truck but the original wood is long gone and it only has three of the five bed floor support sills. The front and rearmost sills are present, but I only have one of the three cross sills that go in the middle of the bed. This...

Thanks, but I found one local to me.

Thanks. I thought as much.

I have a 76 D100 short bed fleetside and I would like to swap to a 1980 short bed stepside. Will a tonneau cover for the fletside fit on the stepside bed? Though I have been around old cars an Mopars for years, this is my first truck. Thanks.

Reed posted a new classified: 72-85 short bed step side pickup bed 72-85 short bed step side pickup bed Read more about the classified...

No, I was trying to understand your post. It was a bit cryptic. I did not know what the "75" in your response was referring to. I have already located a door latch, but how much do you want for a complete ashtray assembly and the mirror base?